cowboy boots

4 Top Tips for Breaking In Your Cowboy Boots


Cowboy boots are comfortable, stylish, and durable, making them a must-have for any wardrobe. However, before you start wearing them with some of your favorite outfits, they need to be broken in to achieve maximum comfort. Don’t let stiff shoes keep you from rocking a cool Western look. Check out these helpful tips for breaking in a new pair of cowboy boots.

Buy the Right Boots

Before you think about breaking in new shoes, it’s important to make sure you get the right type of cowboy boots to begin with. Many cowboy boots today are made with PVC instead of leather. Unfortunately, PVC material is much less flexible than leather, so it’s difficult to break in and can cause discomfort while wearing your boots. Choosing leather boots from a reputable cowboy boots brand like Ariat ensures that you’ll get a much better fit after breaking in your boots.

Use Thick Socks

Wearing your new boots around the house can be a practical and easy way to break them in. For the best results, wear a pair of thick socks or double up with regular socks, then wear the boots in your home doing your typical daily activities. The socks help to stretch out the leather so that your boots eventually feature a little bit of wiggle room for your feet for improved comfort. Start out wearing them this way for short periods of time so your feet aren’t uncomfortable or in pain as the boots slowly loosen up and shape to your feet.

Add Some Steam

Steam heat is a great way to loosen up leather quickly and effectively. Use a garment steamer or boiling water in a kettle and direct the steam so it enters the boot shaft. Allow the leather to warm and loosen up, which will take around 20 to 30 seconds. Then, slip the boots onto your feet and start walking around in them. Keep them on until the boots cool, then remove them carefully and allow them to dry completely before wearing them again. The steam heat process for breaking in cowboy boots should only be used sparingly to maintain the quality of the leather.

Soak Your Boots

Submerging your boots in water is yet another way to help mold new boots to your feet. It’s perhaps the most controversial method for breaking in cowboy boots since water-saturated leather may dry out or fade, but many people swear by it. Simply fill your bathtub with lukewarm water. Submerge the boots as deep as you can without allowing any water to get inside them. Once the insole gets a bit wet, remove the boots from the water.

Next, put on socks and slide your feet into the boots. Walk around in the boots until they are mostly dry. This might take quite a long time, so put the boots on early in the day if possible. Take the boots off and allow them to dry completely and apply leather conditioner before wearing them again.

Use these tips to get the perfect fit for your boots. If these methods don’t do the trick, take your cowboy boots to a professional cobbler for assistance.


Leave a Reply

Your email address will not be published. Required fields are marked *